Changzhou shidai jinhua clutch co., LTD. : how to deal with the pedal failure of the clutch (I)
2019-03-12
A, fault phenomenon: engine idle running, although the clutch pedal has stepped on the ground, but it is difficult to block, transmission gear has the sound of impact. After reluctantly put into gear, has not yet released the clutch pedal, the car has been running or stall.
Two, inspection: remove the clutch cover, the transmission into neutral, the clutch to the bottom. Then, use the screwdriver to move the driven disk. If you can easily turn, the clutch separation is good; If you do not move, the clutch is not completely separated.
Iii. Exclusion:
1. Check whether the free stroke of the clutch pedal is too large and adjust it.
2. Check whether the separation lever height is consistent or too low. In the car under the separation fork, so that the separation of the front end of the bearing gently on the separation of the internal face of the lever, turn the clutch for a week to see, if the internal end of the separation of the lever and the separation of the bearing contact, that the height of the separation of the lever is not consistent, should be adjusted. If the separation lever is of the same height and the separation is still incomplete, check the lever height. The separation lever will be adjusted to the same height, if the complete separation, the original adjustment or wear too much. After separating the lever adjustment, the free stroke of the clutch pedal must be readjust.
This article is arranged by changzhou shidai jinhua clutch co. LTD
